40 lines
1.7 KiB
Plaintext
40 lines
1.7 KiB
Plaintext
To make the pixel, 3D print all 7 parts.
|
|
|
|
The pixel insert (screw) should be in one colour. The case and guide should
|
|
be in a contrasting colour. The small parts can be in any colour, and are
|
|
only visible from the back.
|
|
|
|
Print one pixel before trying to scale up. Some of these objects are difficult
|
|
to print and will require a well set up 3D printer.
|
|
|
|
I printed the large parts on an Original Prusa i3 MK2S and the small parts
|
|
on a Creality CR-10. The printing time was of the order of two weeks plus
|
|
failures and spares.
|
|
|
|
There is some redesigning that would be helpful before scaling up.
|
|
|
|
The pixel also requires 2 nails and a Tower Pro SG90 servo motor.
|
|
|
|
Driving the system requires a Pololu Mini Maestro 24-channel USB Servo
|
|
Controller for each 24 servos.
|
|
|
|
https://www.pololu.com/product/1356
|
|
|
|
Also required is a suitable 5 volt power supply. I used a Mean Well RS-150-5
|
|
for each servo controller. The worst case current of the servo is around an
|
|
amp, and while the average current will never reach anywhere near that, I sized
|
|
the power supplies accordingly so that they should never shut down due to
|
|
transients. The PCB trace on the servo controller is unlikely to be able to
|
|
handle that much current for long.
|
|
|
|
Note that the pixel grid will need external mechanical support. I used parts
|
|
from a couple of monitor stands, but any sturdy vertical pole on either side
|
|
should suffice. Black cable ties will then hold it steady.
|
|
|
|
Assembly should be done carefully. Most parts are push-fit, but that does
|
|
rely on 3D printing tolerances. You may need to slightly adapt some of the
|
|
sizes in the source files to your printer, or be careful about how much
|
|
you file or cut away the rim of the first layer.
|
|
|
|
Prototyping with a single pixel is essential.
|